Realme 10 Pro Plus – Clear HD Membrane Screen Guard + Back Laminate

The Clear HD Membrane Screen Guard for the Realme 10 Pro Plus is a transparent protective film designed to maintain the clarity and responsiveness of your screen while providing defense against scratches, smudges, and minor impacts. It preserves the original brightness and touch sensitivity, ensuring a smooth, crystal-clear viewing experience. The membrane is ultra-thin, allowing for seamless usage with your phone’s display.

The Back Laminate is a protective film applied to the rear of the phone, designed to shield it from scratches, fingerprints, and wear over time. It typically has a glossy or matte finish, preserving the aesthetics of the Realme 10 Pro Plus while adding a layer of protection. The laminate is also ultra-thin and non-bulky, maintaining the phone’s sleek design.

Here’s a step-by-step guide for installing the Clear HD Membrane Screen Guard and Back Laminate on your Realme 10 Pro Plus:

Tools You’ll Need:

• Alcohol wipe or cleaning cloth
• Dust removal sticker (usually included with the screen guard)
• A soft card (like a credit card) to smooth out bubbles
• A clean, dust-free environment

For the Clear HD Membrane Screen Guard:

1. Clean the Screen:
   • Use the alcohol wipe or cleaning cloth to clean the screen thoroughly. Remove any dust, smudges, or fingerprints.
   • Use the dust removal sticker to eliminate any remaining dust particles from the screen.
2. Peel off the Protective Layer:
   • Carefully peel off the protective layer from the adhesive side of the screen guard. Be careful not to touch the adhesive side with your fingers.
3. Align the Screen Guard:
   • Align the screen guard with your Realme 10 Pro Plus screen, ensuring the cutouts for the camera, sensors, and speaker are properly aligned.
4. Apply the Screen Guard:
   • Once aligned, slowly place the screen guard onto the screen. Start from one edge and gently lay it down across the surface.
5. Smooth Out Air Bubbles:
   • Use a soft card to press down gently on the screen guard, moving from the center outward. This will help push out any air bubbles.
   • If you notice dust particles trapped under the screen guard, carefully lift it up using the dust removal sticker and remove the dust before reapplying.
6. Final Check:
   • Ensure the screen guard is applied smoothly, with no bubbles or misalignment.

For the Back Laminate:

1. Clean the Back:
   • Clean the back of your Realme 10 Pro Plus with the provided alcohol wipe or cleaning cloth to remove dirt, smudges, and dust.
2. Peel the Laminate:
   • Carefully peel the back laminate from its protective backing. Be cautious not to touch the adhesive side.
3. Align the Laminate:
   • Align the laminate with the phone’s rear, ensuring it fits well around the camera and other design elements.
4. Apply the Laminate:
   • Gently place the laminate on the back of the phone, starting from one side. Slowly smooth it across the surface.
5. Remove Bubbles:
   • Use a soft card or your fingers to press down and remove any bubbles from the laminate. Start from the middle and work your way out.

Tips:

• Perform the installation in a dust-free environment (like a bathroom after a hot shower) to avoid particles sticking to the adhesive.
• Take your time during alignment to ensure proper fitting.
• If air bubbles persist, use gentle pressure to work them out to the edges.

Once installed, your Realme 10 Pro Plus will be well-protected with a clear, sleek look!